Turf Installation

    Cultivated turf allows you to enjoy a lawn of instant beauty and maturity without the usual time-consuming hassles of seeding.  The following are basic steps to a beautiful lawn.

STEP 1 - Measuring & Ordering

    With a tape, measure the area of your planned lawn.  Include measurements on a sketch of the lawn area, with the length, width, and any unusual features.  Then find the area of your lawn and make sure you take into account any unusual features that you order enough square feet of turf.  

    Schedule your order for delivery of turf after preparatory work is completed and you are ready to install.  Prompt installation on the day of delivery is crucial to a strong beginning for your lawn.

STEP 2 - Soil Preparation

    For best result, rototill or spade the area to the depth of 10 to 15 cm. (4 to 6 in.).  Eliminate drainage problems by having soil slope away from foundations, etc.

    Soil test your lawn area with the assistance of qualified service in your area.  Then rake in fertilizer, lime, peat, compost, etc. as needed to depth of 7 to 10 cm. (3 to 4 in.).  Rake and smooth the soil removing rocks, roots, and large clods.  Roll the are lightly with a lawn roller 1/3 full of water.  This will firm the soil surface and reveal low areas that need more soil.  Keep the grade 2 to 3 cm. (1 in.) below sidewalks or driveway.

    Water the prepared area to settle soil and provide a moist base for turf.  Moistening to a depth of 15 cm. (6 in.) is recommended for most soils.  However, if you have any questions regarding your specific soil needs do inquire your local soil specialist or a soil reference manual. 

STEP 3 - Turf Installation

    Install your lawn immediately upon delivery.  Begin watering your lawn within 30 minutes of installation.  Turf is a living plant that requires ground contact and moisture to survive! 

    In hot weather, protect unlaid turf by placing stacks in shade, covering with moist burlap sacking, and/ or sprinkling.

Begin installing turf along the longest straight line, such as a driveway or sidewalk.  Butt and push edges and ends against each other tightly, without stretching.  Avoid gaps or overlaps.  Stagger the joints in each row in a brick-like fashion, using a large knife to trim corners, etc.  Avoid leaving small strips at outer edges as they will not retain moisture.  On slopes, place the turf pieces across the slope.

    To avoid causing indentations or air pockets avoid repeated walking or kneeling on the turf while it is being installed or just after watering.  After installing the turf, roll the entire area to improve turf/soil contact and to remove air pockets.

STEP 4 - Watering

    Give your new lawn at least 2 to 3 cm. (1in.) of water within 1/2 hour of installation.  Water daily, or more often, keeping turf moist until it is firmly rooted (about 2 weeks).  Then less frequent and deeper watering should begin.

Weather conditions will dictate the amount and frequency of watering.  Be certain that your new lawn has enough moisture to survive hot, dry, or windy periods.  Water areas near buildings more often where reflecting heat dries the turf.

CAUTION

    During first three weeks, avoid heavy or concentrated use of your new lawn.  This gives the roots an opportunity to firmly knit with soil, and insures that the turf will remain smooth.